Home - Vacuum Installation

Aertec Vacuum Installation

Whether you are building a new home or renovating your existing home, there is never going to be a better time to install a Aertec central vacuum system. There are many different types of house builds and the installation method will depend on which type of house build yours is.

Vacuum Intro

Benefits

Installation

Accessories

Units

Vacuum FAQ's

COLUMN WITH BACKGROUND COLOR

Concrete/Block
The 50mm central vacuum pipes will generally go in the ground floor before the concrete floors are finished and upstairs will be piped around the same time as the 1st fix plumbing and electrical is being done. 2nd fixing of wall inlets and the vacuum unit itself can be done towards the end of the build and before final painting.

Timber
1st fixing of the 50mm central vacuum pipes will be carried out the same time as the plumbing and electrical 1st fix. 2nd fixing of wall inlets and the vacuum unit itself can be done towards the end of the build and before final painting.

Because there are so many different types of house builds, we would recommend that you consult with an Aertec engineer before building commences and also during the construction phases to ensure a trouble free and a quality installation. 

---

show all

hide all

• Where is the power unit typically installed?

  The power unit is typically located in a garage, basement or utility room.

• How many square feet will one valve cover?

  One valve will cover approximately 500 square feet of living space. This estimate is based on using a standard 30' hose. If a shorter hose is used, more valves are needed.

• Do systems need to be exhausted to exterior?

  We recommend that all vacuums are exhausted outside, with the exception of garages do not need to be exhausted outside but can be done so on request

• Can I locate the Power Unit in an attic?

  We do not recommend placing the power unit in an attic. The attic space may retain heat and cause the motor to experience premature failure. An attic location may also be difficult to reach when the dirt canister needs emptied.

• How do I recommend the correct power unit for a specific job?

  Each power unit is manufactured with a specific motor to handle a suggested sq. ft. area. All you need to do is figure the homes total square footage and then contact Aertec to specify the best power unit for your home. This is also true for a for Hide-A-Hose installations.

• Can I use plumbers piping?

  The 2" PVC central vac tubing is different from plumbing grade tubing. Central vacuum tubing is manufactured with a completely smooth interior to prevent the tube system from catching small dirt particles and building a clog.

• How long does it take to install a Central Vacuum System?

  Most new home installations can be complete in less than one day.

• What is a rough-in?

  The rough-in consists of determining valve placement and installing the mounting plate, elbow, and drywall cover (this is called a drop), in the wall. Once the home is ready for completion, the installer will return and run the trunk line, low voltage wiring, connect the inlet valves, and hang the power unit.

• Is it possible for objects to get caught in tubing?

  It is not likely as long as the tube system is properly installed. Typically any object that can fit through the inlet valve will be sucked through the tubing and end up in the dirt canister.

COLUMN WITH BACKGROUND COLOR

"Aertec Systems, Your Clean Air Specialist."